The width of the general family garage is 2.4m to 2.8m, and the height is 1.8m to 3.4m. The specific size can be adjusted according to the size of the garage and the size of the vehicle, usually in the form of a flap door or a sliding door. In addition, for the garage of ordinary cars, the width of the garage door is 2.2 to 2.8 meters, and the height is 1.8 to 3.4 meters. If the garage in your home is large enough, you can choose a garage door of 3 meters by 5 meters.
What is the standard size of the garage door
The width of the garage door of an ordinary car is 2.2~2.8 meters and the height is 1.8~3.4 meters. If the garage in your home is large enough, you can choose a 3m * 5m garage door. The size of the garage door is related to the size of the car. Generally, the width of the car is about 2 meters, and the height of the medium-sized car is about 1.6 meters. The size of the garage door is slightly larger than the size of the car.
There is no fixed size for the garage door. The size of the garage door is related to the size of the car, as well as the area of the garage and the number of vehicles parked in the garage.
Installation method of garage door
- Track installation
Determine the position of the two rails according to the width and height of the door panel, measure the level with a horizontal pipe, and then fix it with square head screws. Use a tape measure to measure the distance between the horizontal rail and the wall and between the two horizontal rails, use a level ruler to measure the level of the horizontal rail, and then use screws and hex nuts to connect and fix the horizontal rail connector with the horizontal rail and the rail fixedly.
- Installing torsion spring
Put the torsion spring center bracket, nylon rubber ring, fixed flange, torsion spring, locking flange, winding wheel and bearing bracket matching the weight of the door body onto the galvanized steel pipe in sequence, fix the torsion spring center bracket to the short board at the middle of the upper part of the hole with square head screws, connect the torsion spring center bracket, nylon rubber ring, fixed flange and torsion spring with bolts, and then connect the torsion spring and locking flange. Connect and fix the lower end of the bearing bracket with the connecting piece of the horizontal rail with big cap screws and nuts, and fix the upper end of the bearing bracket to the side wooden frame with square head screws.
- Install the door panel
Place the bottom sealing strip at the bottom of the bottom door panel and fix it to the door panel from the back with self tapping screws. Place the door panel in the erected track and level it.
- Torsion spring strength
Put one end of the steel wire rope loop on the hook shaft of the bottom wheel bracket, and tighten the torsion spring according to the specified stiffening table.
- adjustment
Raise and lower the door several times by hand, observe whether the door body operates stably and whether the force of the torsion spring is appropriate, and then make specific adjustments and tighten the screws of each connecting part.
- Installing motor
Connect and fix the chain box with the motor, connect the power, observe the operation of the motor, and adjust the up and down strokes.
- wiring
Use sheathed wire to lead out from the electric switch terminal at the end of the motor, along the motor hanger to the left side of the hole 1.2m above the ground, and connect the manual switch.