Lost your garage door manual? Forgot your pin? Never knew the pin in the first place? If so then this may help you reset the keypad to a pin you can use. This procedure is for the keypads with the flip up covers, although it may work for others.
Steps
Hold down PROG+6+Up/Dwn, the red LED light on the keypad will go out.
Enter 3+5+7+PROG.
Enter New PIN+PROG, the red LED light on the keypad will blink slowly 2-5 times and go out.
Press Learn Code on the garage door motor, the red LED on the motor will blink.
Enter New PIN+Up/Dwn, the red LED on the motor will go solid.
Press Up/Dwn, the red LED on the motor will go out and the keypad will stay illuminated for about 30 seconds.
Once the keypad backlight is off enter new PIN+Up/Down, the door will close/open.
Tips
- Watch the LEDS to ensure each step was successful.
- Your new pin can be 3-8 digits long.
- In step three for a new PIN 0458 the entry would be 0+4+5+8+PROG
Warnings
- Visibly check the area below the garage door before pressing the Up/Down button.
- Make sure there is nothing obstructing the garage door from opening or closing.